Masker - Weekend Shift -Aerospace

This role is identified as requiring ITAR (International Traffic in Arms Regulations) compliance; therefore, qualified candidates must meet the definition of a U.S. Person (per EAR Part 772 and ITAR 120.15):

• An individual who is granted U.S. citizenship, or
• An individual who is granted U.S. permanent residence (i.e., a "Green Card" holder), or
• An individual who is granted status as a "protected person"

• Reads and interprets blueprints to determine required work procedures and identify materials required
• Using cleaning fluids, solvents, brushes, scrapers, sandpaper, cloth, and/or steam, cleans surfaces of workpieces in preparation for coating
• Follows established work instructions and safety procedures including the proper use of all required personal protective equipment (PPE) and the use, storage, and disposition of hazardous materials
• Uses precision measuring tools such as calipers or other gauges to determine areas needed for masking according to blueprints or drawings
• Uses precision cutting tools such as x-acto style blades/knives to accurately shape masking materials, including tiny materials and hard-to-reach areas requiring manual dexterity with sometimes very limited access
• Applies masking or other such materials to ensure surfaces are protected during processing procedures
• Rinses, drains, and/or wipes coated workpieces to remove excess coating material or to facilitate the setting of finish coats on workpieces
• Demasks and cleans parts as required after coatings or processes have been performed, paying close attention to ensure masking materials applied were correct and adequate in meeting customer/drawing requirements
• Perform other incidental duties as may be required
• Regular attendance on-site at the workplace is required

• A high school diploma or GED equivalent is required
• Experience in precision masking or similar is preferred

• Experience reading and interpreting blueprints; experience interpreting finish specs is preferred
• Precise dexterity and the ability to apply masking in small places and to make precise cuts using an X-acto or similar pointed blade is required
• Hand strength and stability to effectively and accurately use precision cutting instruments is required

• Regularly stand and walk throughout the facility,
• Sit for long periods to perform job duties
• Regularly lift, carry (short distances), and push/pull up to 50 pounds using peer assistance and/or other lifting & material-handling equipment for heavy or oversized parts
• Frequently reaches overhead and reaches out or down to perform duties
• Occasionally climbs steps, stairs, or ladders
• Occasionally bend, crawl, stoop, squat, or kneel
• Frequently uses hand or fingers to manually inspect parts, apply and remove masking materials, and operate precision cutting tools
• Accurately distinguish colors
• Visual acuity to interpret drawings, sketches, and readings on gauges and other measuring devices, and to ensure precise application of masking materials

• Excessive noise (hearing protection required) - occasionally
• Moderate noise - regularly
• Dust, smoke, mist, fumes/vapors (regularly)
• Extreme temperatures (occasionally)
• Hazardous equipment including forklifts, hand tools, sharp blades, cranes or other lifting devices, and other equipment used in a machine shop environment (continually)

If selected for this role, you will be required to complete all assigned online training courses prior to beginning work on the shop floor.

Your first day of orientation will run from 9:00 a.m. to 4:30 p.m.
Following orientation, you will complete the remaining online training from 6:00 a.m. to 4:30 p.m.

Once you transition to the shop floor, you will participate in a three-week, day-shift training period under the guidance of the lead masker.

Upon successful completion of training and based on supervisor assessment, you will then begin your regular assigned shift.